Pratiques et Techniques en Plaisance | Imprimer | Fermer la fenêtre
Port serie et trame NMEA : le standard NMEA0183 5 mai 2015 20:01, par yvesDToujours à propos des références, ce coup ci sur le NMEA 183.
C’est en fait la FAQ que Peter Bennet entretenait dans les années 1998. On en trouve de multiples copies sur internet, dont ici http://fort21.ru/download/NMEAdescr...
On peut y lire, à propops du niveau electrique :
2. Electrical Interface
NMEA 0183 devices are designated as either talkers or listeners (with some devices being both),
employing an asynchronous serial interface with the following parameters :
Baud rate : 4800
Number of data bits : 8 (bit 7 is 0)
Stop bits : 1 (or more)
Parity : none
Handshake : none
NMEA 0183 allows a single talker and several listeners on one circuit. The recommended interconnect wiring is a shielded twisted pair, with the shield grounded only at the talker. The standard dos not specify the use of a particular connector. Note : The new 0183-HS standard (HS = high speed) introduced in version 3.0 uses a 3-wire interface and a baud rate of 38400. This type of interface is not discussed here.
Its is recommended that the talker output comply with EIA RS-422, a differential system with two signal lines, « A » and « B ». Differential drive signals have no reference to ground and are more immune to noise. However, a single-ended line at TTL level is accepted as well. The voltages on the A line correspond to those on the TTL single wire, while the B voltages are inverted (when output A is at +5 V, output B is at 0 V, and vice versa. This is the unipolar RS-422 operation. In bipolar mode ±5 V are used).
In either case, the recommended receive circuit uses an opto-isolator with suitable protection circuitry. The input should be isolated from the receiver’s ground. In practice, the single wire, or the RS-422 « A » wire may be directly connected to a computer’s RS-232 input. In fact even many of the latest products, like hand-held GPS receivers, do not have a RS-422 differential output, but just a single line with TTL or 5V CMOS compatible signal level.
Ce texte clarifie ce que j’ai souvent lu à propos de B qu’on connecte à GND, en fait B c’est le même signal qu’en A mais inversé. Le forcer à 0V REF, pourquoi pas ?
Ceux qui comme moi on adoré le débat autour des USB fusibles lancé par fulup (ici : http://www.plaisance-pratique.com/a... ) seront enchantés de lire The input should be isolated from the receiver’s ground
Enfin pour ceux qui tiennent à lire la norme in-extenso, gogol interrogé avec « nmea 0183 protocol » rend du gros. Cette lecture n’est pas inutile et clarifie encore qui doit faire quoi au niveau électrique.
extrait page 9 avec le schéma d’isolation électrique joint.
On y voit la confirmation que c’est coté talker qu’on doit, si on le souhaite, raccorder l’écran (la tresse de protection) à une terre. le § 3.5.4 m’inquiète un poil.